Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 18
GB
F
D
E
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine does not reach full speed 1. Check oil fuel mixture.
and emits excessive smoke.
Engine starts, runs, and
accelerates but will not idle.
Blade continues to rotate
at idle speed.
I
P
NL
S
DK
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder
now than when new.
Carburetor requires
adjustment.
2. Air filter dirty.
3. Carburetor requires
adjustment.
Carburetor requires
adjustement
Carburetor requires.
adjustment.
N
FIN GR HU
CZ RU
English

TROUBLESHOOTING

SOLUTION
1. Check spark. Remove sparking plug. Reattach the
sparking plug cap and lay sparking plug on metal
cylinder. Pull the starter rope and watch for spark
at sparking plug tip. If there is no spark, repeat
test with new sparking plug.
2. Push primer bulb until bulb is full of fuel. If bulb
does not fill, primary fuel delivery system is
blocked. Contact a service dealer. If primer bulb
fills, engine may be flooded (see next item).
3. Remove spark plug, turn trimmer so spark plug
hole is aimed at the ground. Make sure lever is
in the open choke (
cord 10 to 14 times. This will clear excess fuel
from engine. Clean and reinstall spark plug. With
the throttle trigger fully depressed, pull starter
cord three times with lever at open choke (
) position. If engine does not start, move choke
lever to close choke (
normal starting instructions in "STARTING AND
STOPPING" section. If engine still fails to start,
repeat procedure with a new spark plug.
4. Contact a service dealer.
Contact a service dealer.
1. Use fresh fuel and the correct synthetic 2-stroke
oil mix.
2. Clean air filter. Refer to "Replacing and Cleaning
Air Filter" earlier in this manual.
3. Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
26
RO PL SLO HR TR EST LT
) position and pull starter
) position and follow
LV
SK BG

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Rbc-40sb

Inhaltsverzeichnis