Changing Filter On Request - K-FEE Grande Original Bedienungsanleitung

Changing filter on
EN
9
request (2)
Discard used water filter.
12
Risk of scalding!
Very hot water.
The appliance rinses with
200 ml of water.
min.
0,25 l
Place a container (min.
0.25 l) under the spout.
When using a water filter
15
for the first time, set the re-
spective parameter to "on".Please
read the instructions on "Setting
parameters - water filter" on page
48. The setting will be retained,
also following an interruption in
the power supply.
The light of the water filter
symbol has gone out. Then
the machine switches off
46
automatically.
11
10
max.
3.5 l
Screw in new water filter. Refill water tank completely
and re-insert.
13 14
Press rinse button. Wait until rinsing process is
finished.
Then empty container.
1 2
Off
3 sec. min.
Firstly, switch off the machine. The descaling symbol lights
Then hold the rinse button up on the display.
down for at least 3 sec.
4 5
For cleaning hold the
rinse button down for more
than 3 sec. and follow the
steps described on page 41
from figure 5.
Press the rinse but-
ton only briefly to
start the next function.
The cleaning symbol lights
up on the display.
7 8 8
For replacing the filter
hold the rinse button down
for more than 3 sec. and
follow the steps described
on page 45 from figure 5.
In order to return
to descaling, press
the rinsing button only
briefly.
Descaling symbol lights up
again (program loop).
Cleaning, descaling and
3 For descaling hold the
filter replacement on
rinse button down for more
than 3 sec. and follow the request
steps described on page 43
from figure 5.
This function can be used to
start descaling or cleaning
Press the rinse but-
or to carry out a filter change at the
ton briefly to start
operator's discretion.
the next function.
The filter symbol will only
6
appear if the "water filter"
parameter has been set to "on".
The filter symbol lights up on
the display.
11 9
To leave the program loop
press the on/off button.
EN
47