Shark Evo-One Benutzerhandbuch Seite 15

rePlacing the interior PaDDing
- Reposition the cheek pads by passing the
chin straps through the slit in the foam (Fig.
A) and clip all the studs from the two cheek
pads (Fig. B).
- Start the operation by sliding the plastic
tabs of the front of the head section in its
housing beginning with one side (Fig. C).
- Position the padding correctly inside the
top of the helmet.
- Raise the cheek pad by inserting the back
piece and then replacing the hooks on
the side parts one after the other (Fig. D).
Check that the headgear has been placed
in the right direction.
Warning! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal
or replacement of the interior padding,
DO NOT USE YOUR HELMET. Contact your
retailer for assistance or advice. NEVER
use your helmet with any part of the
interior padding removed. The helmet will
not protect you in an accident.
Warning! The polystyrene lining and
interior padding are critical to proper-
ly fit your helmet on your head. An improper
fit could cause your helmet to become
dislodged in an accident, leaving your head
unprotected and resulting in severe head
injury or death. If you are not sure that
you properly replaced the comfort padding,
DO NOT USE YOUR HELMET. Contact your
retailer for assistance or advise.
textiles Parts
a
B
c
D
15