Choosing The Power Supply; Open The Box; Board Description - Videotec WAS Bedienungsanleitung

6.2 Choosing the power supply

Depending on the version, the device can be
provided with different power supply voltages. Their
value is shown on the product identification label.
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Check that the power supply socket and
cable are adequately dimensioned.
Use a power cable that is suitable for
outdoor use (example: H05RH-F).

6.3 Open the box

The operation is performed only for a pump
with a 5m or 11m delivery head.
Open the cover of the water-proof box and connect
as described below.
Fig. 4
8

6.4 Board description

The operation is performed only for a pump
with a 5m or 11m delivery head.
BOARD DESCRIPTION
Connector Function
J5 Power supply for the board
FUS1 Power supply selection fuse (230Vac)
FUS2 Power supply selection fuse (120Vac)
FUS3 Power supply selection fuse (24Vac)
Tab. 1
Fig. 5
FUS1
FUS2
FUS3
J5
MNVCWAS_1744_EN