Technical Data; Cs 2512 - Husqvarna CS 2512 Bedienungsanweisung

CS 2512

Power on drive wheel (with PP 455), kW
Hydraulic oil flow, l/min / gpm
Max. hydraulic pressure, bar/psi
Max recommended hydraulic pressure when cutting, bar/psi
Maximal wire length in the magazine (2.4 m/wheel set), m
Dimensions, handle folded in and the guard folded down (L x W x H), mm
Weight, kg/lbs
Wire speed gear 1, m/s / ft/s
Wire speed gear 2, m/s / ft/s
Noise emissions (see note 1)
Sound power level, measured dB(A)
Sound power level, guaranteed L
Sound levels (see note 2)
Sound pressure level at the operators ear, dB(A)
Note 1: Noise emissions in the environment measured as sound power (L
Note 2: Noise pressure level according to EN 15027/A1. Reported data for noise pressure level has a typical statistical dispersion
(standard deviation) of 1.0 dB(A).
Magazine capacity
MIN. length in machine, m
Absorbing length, m
MAX. length in machine, m
Recommended wires
Husqvarna recommends that the following wires are used:
Husqvarna C710C
Husqvarna C750C
Husqvarna C760C
Husqvarna C790C
Husqvarna C575J
C1200M
For further information about different tools from Husqvarna, contact your Husqvarna dealer.
14 –
English

TECHNICAL DATA

dB(A)
WA
Number of magazine wheel pairs
1
3,4
2,4
5,8
Husqvarna C710C is a galvanised wire developed for use when
cutting concrete with a great deal of reinforcement. The segments
have a great number of diamonds and a smaller diameter (9.5mm)
which means the wire cuts very efficiently. The smaller diameter also
means that C710C can be used to finish difficult cuts.
Husqvarna C750C is an all round wire developed for use when cutting
reinforced concrete. The wire has been designed for use with saws
with an output power between 10 and 25 kW.
This is the Husqvarna premium wire: long life, high cutting rate and
high power resistance characterize this wire. Husqvarna C760C can
be used to cut all types of reinforced concrete, even when the work
places high demands on the wire, for example when cutting bridges.
The segment strength on this wire makes Husqvarna C790C the best
choice when cutting soft materials such as mortar, and lightly
reinforced limestone concrete.
Husqvarna C575J is a wire with galvanised 15 mm segments.
Husqvarna C1200M is a wire developed for use when cutting steel.
The wire has been designed for use in extremely demanding
situations. The use of the latest sintering technique has given
enormous advantages with regard to cutting rates and life span. The
wire can be supplied with either joined or loose ends.
20
65/17
230/3400
130/1900
12
1150x750x980
150/330
20/66
25/82
94
95
83
) in conformity with EN 15027/A1.
WA
2 3 4 5
4,4 5,5 6,5 7,5
4,8 7,2 9,6 12
9,2 12,7 16,1 19,5