Program Description - Bosch BEA 750 Originalbetriebsanleitung

4.6 Anti-glare film
The anti-glare film included with delivery can be at-
tached to the touchscreen of the BEA 065 to minimize
reflections. The touchscreen must be absolutely dust-
and grease-free before the anti-glare film is attached.
Use the provided cleaning cloths for this purpose. Air
bubbles that may become trapped under the anti-glare
film can be removed with the aid of a squeegee.
4.7 Selecting the external network printer
!
Repeaters installed in the WLAN can cause commu-
nication interruptions when using a network printer.
Make sure that the repeater permits data exchange
via broadcast or multicast messages. Provide the
same functionality for a switch and router.
i
To print out the protocols (test records) on an exter-
nal network printer, it is first necessary to set up a
network connection for the network name (SSID) in
the BEA-PC software under "Settings >> Operating
System >> WLAN" (see Online Help).
1. In the BEA-PC software, open "Settings >> Proto-
col".
2. Insert the USB stick into the USB port (rear of the
BEA 065).
3. Select "Printer >> External Network Printer".
4. After a short time, <F8> Print Service appears.
5. Press <F8>.
 The file 'PrintServiceSetup.exe' is saved on the
USB stick.
6. Remove the USB flash drive from the BEA 065, and
insert it in the selected network computer.
7. Start the file 'PrintServiceSetup.exe' on the USB
stick.
8. Follow the instructions on the screen.
 Once installation is complete, the active printers
in the network are displayed in the BEA-PC soft-
ware under "Settings >> Report".
9. Select the printer.
Robert Bosch GmbH
Initial commissioning | BEA 750 | 17
10. Press <F12> to save changes and return to the "Set-
tings" window.
"
The external network printer is configured.
i
In rare instances, no active printer is displayed in
the indicator panel under "Settings >> Protocol"
when selecting the network printer. In this case, the
BEA 750 must be restarted.
4.8

Program description

i
All information regarding operation of the "BEA-PC"
software is available in the Online Help. The Online
Help can be opened in the software by pressing <F1>.
4.9 AU Plus
i
Information on the AU Plus settings can be found in
the Online Help.
4.10 BEA-PC software update by means of
USB stick
1. Insert the USB stick with the BEA-PC software up-
date into any USB port on the computer board (fig.
3, item 3 or 4).
 After a few moments, the <F7> Update softkey
appears on the start screen of the BEA-PC soft-
ware.
2. Press <F7>.
3. Then follow the instructions on the screen.
en
|
1 689 989 317 2016-12-14