Nilfisk SC2000 Bedienungshandbuch Seite 71

revised 07/2017
Squeegee installation
1. Install the squeegee (A, Fig. 3) and fasten it to the bracket
(C) with the handwheels (B).
2. If necessary, adjust the squeegee with the knob (D) so that
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.
Solution tank filling
CAUTION!
Use only low-foam and non-flammable
detergents, intended for automatic scrubber
applications.
WARNING!
When using floor cleaning detergents, follow
the instructions on the labels of the detergent
bottles.
To handle floor cleaning detergents, wear
suitable gloves and protections.
NOTE
If the machine is equipped with EcoFlex system
(optional) pour clean water in the tank, otherwise
pour solution.
1. Ensure that the solution valve (9) is open (9-A).
2. To fill the solution tank (15) remove the plug (25) to reach
the filler neck.
(For machines without EcoFlex system)
3. Fill the tank (15) with a solution suitable for the work to be performed.
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (16) as reference.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
(For machines with EcoFlex system)
4. Fill the tank (15) with clean water. If equipped, use the water filler hose (optional) located in the filler neck (25).
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (16) as reference.
The water temperature must not exceed 40 °C.
Detergent tank filling (For machines with EcoFlex system)
5. Lift the cover (18) and check that the recovery tank (17) is empty, otherwise empty it with the drain hose (26).
6. Close the cover (18).
7. Grasp the handle (35) and carefully lift the recovery tank assembly (17).
8. Fill the tank (38) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few inches from the edge.
NOTE
In case of new system, system emptied for cleaning, etc., wait for the hoses to fill up completely before turning on.
In order to fill the EcoFlex system quickly it may be useful to drain it once or several times (see the procedure in
Maintenance chapter).
01/2015
INSTRUCTIONS FOR USE
F
Figure 3
9100000383 - SC2000
ENGLISH
C
A
B
D
B
E
P100865
13