Assembly; Fit The Wheel Kit; Secure The Stand - Husqvarna DS 250 Bedienungsanweisung

Fit the wheel kit

• Fit the wheel set in the mount on the backside of the
bottom plate and tighten the screws.

Secure the stand

There are three methods for fixing the stand.
• Securing with vacuum plate
• Fixing with expander or anchor
• Fixing with threaded rod, washer and lock nut
Securing with vacuum plate
WARNING! The vacuum plate must never be
!
used for ceiling or wall drilling. Careless or
incorrect use can result in serious, even
fatal injury.
If the vacuum plate is used, make sure the
support surface is not porous and can
loosen from the floor or the wall. Make sure
that the vacuum pump has sufficient power
to secure the vacuum plate.
• Connect the vacuum pump to the quick coupling for
vacuum pressure on the base plate.
• Place the bottom plate in the desired position.
• Switch on the vacuum pump. A minimum pressure of 635
mm Hg (25 inch Hg) must be reached so that the base
plate seals tightly against the surface.
8 –
English

ASSEMBLY

Fixing with expander or anchor
IMPORTANT! When drilling roofs, only expander or anchor
suitable for surfaces exposed to tensile forces should be
used.
Use only expander or anchor which is approved for current
application.
DS 150
• Drill a hole for the expander/anchor at a distance of 293
mm (11.5") from the center of the hole.
• Bolt down the base plate. Check carefully that the
expander is secured correctly.
• The bottom plate can be adjusted to the surface by using
the leveling adjustment screws. Use the feed lever.