Charging The Battery - Fronius Acctiva Single Bedienungsanleitung

Charging the battery

General remarks
Important! Parallel operation of consumers (e.g. radio, hand-held lamps, etc.) is possib-
le during the charging process. Parallel operation of consumers may lengthen the
charging time. If the power consumed is greater than the maximum available charging
current, the battery may be drained. Ensure that the power used for additional consu-
mers is less than the maximum available charging current (see Technical Data).
Charging the To start charging, proceed as follows:
battery
1.
2.
3.
4.
5.
6.
7.
8.
Final charging
Important! The charger automatically switches to conservation charging after approx. 1
hour, depending on the type of battery. To charge the battery completely, the battery
should remain connected to the charger for this length of time.
WARNING! Risk of explosion from short circuits and arcs. Before connecting
to/disconnecting from battery, disconnect charger from mains supply. During
operation, check that charging terminals and battery poles are properly
connected.
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
Disconnect charger from the mains
Switch off engine and ignition, switch off all consumers
Connect (+) charger lead to positive pole (red) on battery
Connect (-) charger lead to negative pole (black) on the battery, or to vehicle body
(e.g. engine block) in the case of vehicle power supplies.
Charger starts to charge
LED indicator shows charging is taking place
Charger switches to „final charging" when the battery is 80 - 85 % charged
The battery is ready for use.
„Final charging" indicator flashes
5