Overview - Futurelight CP-256/32 Bedienungsanleitung

4.2 Overview

Overview on the control elements
1) CHANNEL FADERS
For adjusting the different DMX-values. The channels 1-8 can be adjusted directly after pressing the
respective projector select button. The channels 9-16 can be adjusted after pressing the Menu-button.
2) PROJECTOR SELECT BUTTONS
With the Projector select buttons you can choose the desired projector.
3) MANUAL BUTTON
By pressing the Manual button, you can adjust the projector manually.
4) RECALL BUTTON
By pressing the Recall button, the manual mode is deactivated.
5) SEQUENCE BUTTON
6) UP/DOWN BUTTONS
By pressing the respective button, you can adjust the settings stepwise. If you hold the respective button,
the display moves upwards or downwards, respectively.
7) MENU BUTTON
By pressing the Menu button, you can move within the main menu.
In the manual mode, you can switch the channel faders from CH 1-8 to CH 9-16 by pressing the Menu
button.
8) DISPLAY
9) LEFT/RIGHT BUTTONS
10) ESC BUTTON
Via the Escape button, you can exit the active menu. If there are any changes, you can save them via
the Enter button or cancel them via the Esc button.
11) ENTER BUTTON
For confirming the adjustments.
12) SCENE BUTTON
13) PROGRAM BUTTON
14) RECORD BUTTON
15) COPY BUTTON
16) ENCODER
With the encoders you can move the light beam manually.
17) SPEED-CONTROL
18) RATE-CONTROL
19) DATA ENTRY FADER
20) MUSIC TRIG BUTTON
If this LED flashes, the controller is in Audio-mode (operation with sound-control).
21) POWER/BLACKOUT BUTTON
With the power switch, you can take the controller into operation.
The Blackout-function closes the light output of all connected projectors via the shutter.
Caution: The Blackout-key has to be pressed (LED is off), as soon as a program is called up. Otherwise
there will not be any light output.
25