Filling The Detergent And Additives - Electrolux WASL3E202 Benutzerinformation

If you put in the drum more
laundry than the maximum
load, the symbol
value start to flash. You can
wash your laundry but the
water and energy consumption
increase. To have the best
consumption and washing
performance remove some
items until the symbols stop to
flash. The overload indication is
available only for programmes
with a maximum load lower
than the appliance maximum
load.
3. Close the door.
The value near the symbol
display shows the quantity of the
detergent to use.
This data is indicative and refers to the
detergent quantity for a maximum load
that the manufacturer recommends.
4. Make sure that no laundry stays
between the seal and the door.
There is a risk of water leakage or damage
to the laundry.
11.5 Filling the detergent and
additives
and the
on the
11.6 Check the position of the
flap
1. Pull out the detergent dispenser until it
2. Press the lever down to remove the
3. To use powder detergent, turn the flap
Compartment for prewash phase an
soak programme.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of liquid
additives.
Compartment for stain remover.
Flap for powder or liquid detergent.
Always obey the instructions
that you find on the packaging
of the detergent products.
stops.
dispenser.
1
up.
ENGLISH 17
2