Husqvarna FS 700 EX Bedienungsanweisung Seite 68

Start blade rotation by turning the switch towards the lamp
that is on. If the switch is turned in the opposite direction
the blade will rotate in the wrong direction.
1
Feed the saw blade by turning the blade feed lever
towards you, so that a cutting depth adapted to the floor
material, however at least 20 mm, is realized.
Make a pilot cut at an even speed at this depth along the
pre-drawn line. When the complete pilot cut has been made,
raise the blade, shut off the water coolant and stop the blade
rotating. Reverse the machine to the starting point.
Align the machine with the pilot cut again and start the
machine as above.
Lower the saw blade to a suitable cutting depth (5-10 cm).
A suitable cutting depth varies depending on the floor
material and the speed.
A simple rule is if the machine tends to "climb up" out of
the pilot cut the cutting depth is too large and/or the speed
too high.
The machine must not be driven faster than that it cuts
without "climbing" i.e. that the machine's front wheels lift
off from the ground. If the machine "climbs", decrease the
trolley feed by turning the lever for the travel feed
anticlockwise or raise the blade by turning the blade feed
lever clockwise
NOTE!
The operator must always be behind the
machine when cutting and within reach of the
levers and stop.
WARNING!
Contact with the rotating saw blade can
result in serious, physical injury or even
death.
68 - English
0
1
Stop cutting
Lift up the cutting bridge to its highest position.
Shut down blade rotation by turning the switch the neutral
position.
Turn both the travel feed and blade feed to their neutral
positions.
Shut off the water coolant.
NOTE!
The protective devices are for your own
safety, consequently, it is extremely important
to check all safety equipment regularly. Should
a fault be discovered, please contact your
dealer.
Operator's Manual FS 700EX