Husqvarna FS 700 EX Bedienungsanweisung Seite 63

Operator's Manual FS 700EX
and the trolley feed lever is in the neutral position or
the machine is not voltage fed, this position acts as a
parking brake.
If the foot lever is switched to the other position no
gear is engaged and the machine is easy to move. Use
this position when the machine needs to be
transported over long distances.
11.Hose holder
The user can use the hose holder to prevent hoses
and cables trailing behind the machine. These will lie
to the side of the machine instead.
12.Blade guard
Can be fitted on either the right or left-hand side of the
machine as required. The guard can be secured in the
upright position by using the lever on the rear edge of
the guard.
13.Splash guard
The machine is equipped with a folding splash guard to
minimise water spray and dirtying. When the machine
is transported over long distances the splash guard
should be folded up and secured using the spring on
the blade guard. The splash guard should always be
folded down when cutting.
14.Blade flange
The blade flange fits on either side of the machine to
allow the blade to be easily fitted on both sides of the
machine
The blade flange should be covered with the blade
flange guard when a blade is not fitted The blade
flange guard is fitted on the right-hand side on delivery.
The machine is supplied with a standard blade flange.
A flush cutting blade flange can be purchased as an
option. Fit the blade on the flush cutting blade flange
when the cut is to be made next to a wall. A special
flush cutting blade guard must be used when cutting
flush.
15.Handle setting
The height of the handle can be adjusted by loosening
these two screws to the most suitable height.
16.Adjuster screw
Adjust this screw to tension the drive belt.
14
English - 63