Herunterladen Inhalt Inhalt Diese Seite drucken

Toshiba RAS-3M18SAV-E Einbauanleitung Seite 9

Multisystem-splitgerät
Vorschau ausblenden Andere Handbücher für RAS-3M18SAV-E:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

01_OutdoorInstallation_EN.fm Page 7 Monday, February 5, 2007 4:11 PM
CAUTION
1.
Install the outdoor unit in a location where there are no obstructions near its air intake or air outlet.
2.
When the outdoor unit is installed in a place that is always exposed to strong winds like on the coast or on a high story of a
building, secure the normal fan operation using a duct or a wind shield.
3.
Especially in windy areas, install the unit to prevent the admission of wind.
4.
Installation in the following places may result in trouble. Do not install the unit in such places.
• A place full of machine oil.
• A saline-place such as the coast.
• A place full of sulfide gas.
• A place where high-frequency waves are likely to be generated, such
as from audio equipment, welders, and medical equipment.
Draining the water (heat pump models only)
• Holes are provided on the base plate of the outdoor unit to ensure that the
defrost water produced during heating operations is drained off efficiently. If a
centralized drain is required when installing the unit on a balcony or wall, follow
the steps below to drain off the water.
1.
Proceed with water-proofing by installing the water-proof rubber caps
2 elongated holes on the base plate of the outdoor unit.
[How to install the water-proof rubber caps]
1) Place four fingers into each cap, and insert the caps into the water drain
holes by pushing them into place from the underside of the base plate.
2) Press down on the outer circumferences of the caps to ensure that they
have been inserted tightly.
(Water leaks may result if the caps have not been inserted properly, if their
outer circumferences lift up or the caps catch on or wedge against
something.)
c
2.
Install the drain nipple
and a commercially available drain hose (with 16 mm
inside diameter), and drain off the water.
(For the position where the drain nipple
diagram of the indoor and outdoor units.)
• Check that the outdoor unit is horizontal, and route the drain hose at a
downward sloped angle with very little slack to the hose.
d
in the
c
is installed, refer to the installation
7
Strong
wind
d Water-proof rubber
caps (supplied with the
outdoor unit)
Base plate
c Drain nipple
Base plate
c Drain nipple
Commercially available
drain hose
Do not use ordinary garden hose, which can flatten and
prevent drainage.
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis