Replacing The Lamp - Electrolux EN3854MFX Benutzerinformation

Problem
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the temper-
ature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
Food products placed in
the appliance were too
warm.
The FastFreeze function is
switched on.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The FastFreeze or Shop-
pingMode function is
switched on.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The FastFreeze function is
switched on.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func-
tion".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "Fast-
Freeze or ShoppingMode
function".
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FastFreeze func-
tion".
21