Built-In Appliances; Connection Cable - Electrolux GK29TCO Benutzerinformation

• PNC .............................
• Serial number ....................
WARNING!
During installation in combustible
matter, NIN SEV 1000 and fire
protection guidelines and regula-
tions of the Association of Canto-
nal Fire Insurance shall be strictly
adhered to.

8.1 Built-in appliances

• Only use the built-in appliances after
you assemble the appliance into correct
built-in units and work surfaces that
align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with
a special cable (type H05VV-F or high-
er). Speak to your local Service Centre.
8.3 Electrical connection
• Install the appliance with a socket sup-
ply line. If there is no socket supply line,
the fixed home electrical system must
include an isolating device with at least
a 3 mm-contact separation to enable a
simultaneous and all-pole cut off from
the mains (according to NIN SEV 1000).
8.6 Assembly
min.
500mm
Mounting on the top
8.4 To attach the seal to the
rabbet
• Clean the rabbet in the work surface.
• Bond the seal stripe supplied on the
upper surface of the rabbet along the
edges of the cut out section.
• Cut the seal stripe into four pieces in re-
lation to the length of the edges of the
rabbet.
• For the four corners of the rabbet the
ends of the seal stripes must be cut in-
to mitres. Do not bond the ends over
one another.
• Bond the seal stripe flush into the cor-
ner of the rabbet. Make sure that no sil-
icon compound can get below the
glass ceramic when grouting.
• Do not extend the tapes.
8.5 To attach the seal.
• Clean the worktop in the area of the cut
out section.
• Bond the seal stripe supplied on the
lower edge of the appliance along the
outer edge of the glass ceramic. Do not
extend it. Let stay the cut ends in the
middle of one side. When, you cut it to
length (add some mm), push the two
ends together.
min.
50mm
ENGLISH 61