Installation; Built-In Appliances; Connection Cable - Electrolux EHI6740F9K Benutzerinformation

16 www.electrolux.com

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................

8.1 Built-in appliances

• Only use the built-in appliances after
you assemble the appliance into correct
built-in units and work surfaces that
align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-
nection cable.
One phase connection — 230 V~
230V~
N
L
Green — yellow
N Blue and gray
L Black and brown
• Replace the damaged mains cable only
with the spare parts cable. Speak to
your local Service Centre.
Two phase connection
1. Remove the cable end sleeve from
black and brown wires.
2. Remove insulation of the brown and
black cable ends.
3.
Apply a new wire end sleeve of 1.5
mm² on each cable end. (Special tool
required)
WARNING!
All electrical connections must be
made by a qualified electrician.
CAUTION!
Do not drill or solder the wire
ends. This is strictly forbidden!
WARNING!
Do not connect the cable without
cable end sleeve.
400V 2~N
Two phase connection — 400 V 2 ~
Green — yellow
Blue and gray
Black
Brown
N
L1
L2
N
N
L1
L2