Built-In Appliances; Electrical Connection - Electrolux GK29TCO Benutzerinformation

50 electrolux
Warning! During installation in
combustible matter, NIN SEV 1000 and
fire protection guidelines and
regulations of the Association of
Cantonal Fire Insurance shall be strictly
adhered to.

BUILT-IN APPLIANCES

• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
CONNECTION CABLE
• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with a
special cable (type H05VV-F or higher).
Speak to your local Service Centre.

ELECTRICAL CONNECTION

• Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must include
an isolating device with at least a 3 mm-
contact separation to enable a simultane-
ous and all-pole cut off from the mains
(according to NIN SEV 1000).
TO ATTACH THE SEAL TO THE
RABBET
• Clean the rabbet in the work surface.
ASSEMBLY
min.
500mm
Mounting on the top
• Bond the seal stripe supplied on the up-
per surface of the rabbet along the edges
of the cut out section.
• Cut the seal stripe into four pieces in rela-
tion to the length of the edges of the rab-
bet.
• For the four corners of the rabbet the
ends of the seal stripes must be cut into
mitres. Do not bond the ends over one
another.
• Bond the seal stripe flush into the corner
of the rabbet. Make sure that no silicon
compound can get below the glass ce-
ramic when grouting.
• Do not extend the tapes.
TO ATTACH THE SEAL.
• Clean the worktop in the area of the cut
out section.
• Bond the seal stripe supplied on the low-
er edge of the appliance along the outer
edge of the glass ceramic. Do not extend
it. Let stay the cut ends in the middle of
one side. When, you cut it to length (add
some mm), push the two ends together.
min.
50mm