Parallel Connection; Each Device; Mechanical Limit Positions; Operation Of Unit - Nice Patio Installations- Und Bedienungsanleitung

4 2 1 Parallel connection

Multiple devices can be connected in parallel.
However, in this case the devices will not behave synchronously.
4 2 2 Minimum current of customer-provided power supply
for each device
Model of device
1500 N
Tab. 2 Minimum current

4 3 MECHANICAL LIMIT POSITIONS

Factory setting:
The limit positions have been preset to the dimensions corresponding
to the stroke length defined in the order confirmation.
The device does not have a limit switch to shut it off when it reaches
the limit positions.
Upon reaching the limit stops, the device must switch off by means
of an overcurrent safety device (see chapter „4.2 Electrical connec-
tion").

4 3 1 Operation of unit

WARNING
Damage to the device due to wrong operation.
– Fast polarity reversal of the traversing direction of
the device is not permissible.
– The device must come to a complete standstill
before switching the traversing direction.
12 – ENGLISH
Rated voltage 24 V DC
4 A
If the device is blocked during a stroke traverse, the in-
creased motor current will shut it off (overcurrent shut-off).
The device remains at a standstill and requires a renewed
traversing signal. However, the device will not traverse
again until the cause of the blockade has been eliminated.
5

WASTE DISPOSAL

5 Waste disposal

5 1 SCRAPPING

When scrapping the device, the currently applicable international, na-
tional and regional laws and regulations must be observed.
Ensure that the recycling, dismantling and separation ca-
pabilities of the materials and assemblies, as well as the
environmental and health dangers, are taken into consid-
eration during recycling and waste disposal.
Material groups, such as plastics and metals of different types, must
be sorted before being sent for recycling or disposal.
5 2 DISPOSAL OF WASTE ELECTRICAL AND
ELECTRONIC COMPONENTS
The disposal and recycling of electrical and electronic components
must be carried out in accordance with the respective laws or national
regulations.