Specifications - Makita 9077 Bedienungsanleitung

ENGLISH
1-1. Shaft lock
2-1. mark
2-2. Motor housing
2-3. Lock button
2-4. Handle
3-1. Switch trigger
3-2. Lock lever
5-1. Wheel guard
5-2. Screw
5-3. Lever
5-4. Notch

SPECIFICATIONS

Depressed center wheel diameter
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
Explanation of general view
6-1. Lock nut
6-2. Depressed center wheel
6-3. Inner flange
7-1. Lock nut
7-2. Depressed center wheel
7-3. Inner flange
8-1. Lock nut wrench
8-2. Shaft lock
9-1. Lock nut
9-2. Outer flange 78
9-3. Cut-off wheel
Model
Spindle thread
-1
)
Overall length
Net weight
Safety class
equipment
environmentally compatible
9077/9077S
180 mm
M14
7,600
484 mm
5.3 kg
END202-2
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.25 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
and its
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 88 dB (A)
sound power level: 101 dB (A)
The typical weighted root mean square acceleration
ENE048-1
value is 3 m/s
EC-DECLARATION OF CONFORMITY
Model; 9077,9077S,9077SL,9079,9079S
ENF002-1
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
4
9-4. Inner flange 78
9-5. Dust collecting wheel guard
11-1. Exhaust vent
11-2. Inhalation vent
12-1. Commutator
12-2. Insulating tip
12-3. Carbon brush
13-1. Brush holder cap
13-2. Screwdriver
9077SL
180 mm
M14
6,000
484 mm
5.3 kg
/II
Wear ear protection.
2
.
9079/9079S
230 mm
M14
6,000
484 mm
5.3 kg
ENF100-1
ENG006-1
ENH101-8