Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, remove the key
(if equipped), wait for all moving parts to stop, and
disconnect the wire from the spark plug before
examining the machine for damage. Make all
necessary repairs before resuming operation.
•
Before leaving the operating position, shut off
the engine, remove the ignition key (electric-start
model only), and wait for all moving parts to stop.
•
If the engine has been running the muffler will be
hot and can severely burn you. Keep away from
the hot muffler.
•
Check the grass catcher components and
the discharge chute frequently for any wear
or deterioration and replace them with the
manufacturer's recommended parts when
necessary.
•
Use accessories and attachments approved by
The Toro® Company only.
Slope Safety
•
Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes.
•
Do not mow on excessively steep slopes. Poor
footing could cause a slip-and-fall accident.
•
Mow with caution near drop-offs, ditches, or
embankments.
Starting the Engine
1.
Hold the blade-control bar against the handle
(A of
Figure
13).
2.
Pull the recoil-start handle lightly until you feel
resistance, then pull it sharply, and allow it to
return to the rope guide on the handle slowly (B
of
Figure
13).
Figure 13
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-Propel Drive
To operate the self-propel drive, simply walk forward
or backward with your hands on the upper handle
and your elbows at your sides, and the machine will
automatically keep pace with you
Note:
If the machine does not freely roll forward
or backward after self-propelling, stop walking, hold
your hands in place, and allow the machine to roll a
couple of centimeters (inches) forward to disengage
the wheel drive. You can also try reaching just under
the upper handle to the metal handle and pushing the
machine forward a couple of centimeters (inches). If
you are having issues propelling in reverse, slightly lift
the handle. If the machine still does not roll backward
easily, contact an Authorized Service Dealer.
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, both the engine and blade should stop within
3 seconds. If they do not stop properly, stop
using your machine immediately and contact an
Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
g230459
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to
Removing the Side-Discharge Chute (page
13).
11
(Figure
14).
Figure 14
12). If
g038503
Werbung
Kapitel
Inhaltsverzeichnis
