Switching On Remotely; Special Setting "Greeting Only - AUDIOLINE DECT 7800 Bedienungsanleitung

8.5.4

Switching on remotely

Imagine that you have left your office or your house and have forgotten to switch on
your answering machine. Using the remote access facility, you can switch on the
answering machine from another telephone.
1. Call your number and let it ring until your call is answered (ca. 9 times).
Press the * button while your greeting message is playing and then enter
2.
your personal PIN code by pressing the appropriate numbers on the number
pad of the remote control or telephone. Entry of the correct code will be
confirmed with a signal tone.
Press 7 and your answering machine will be switched on.
3.
4. Now put the receiver down or make use of further remote access functions.
8.5.5

Special setting "Greeting only"

Normally the caller will be able to leave a message following your greeting. If you do
not want the caller to be able to leave a message, you can switch to the "Greeting
only" mode. The call will be terminated by your answering machine immediately
after your greeting. Remember that in this case you must change your greeting
message.
Programming steps
1. Press the
Now press the digits 9 and 8.
2.
3. You can choose the required setting
with the buttons
(3).
4. Confirm with
68
- The answering machine -
button.
(1) and
.
Indication in the display
The symbol
1/1 current setting
1/1 normal recording
or
1/1
flashes
Greeting only