Installation / First Use; Unpacking The Device - Satelec P5 Newtron XS Gebrauchsanleitung

Depth: 290mm
Weight: 1700 g
Footswitch:
Width: 70mm
Height: 30mm
Depth: 95mm
Weight: 150g
Handpiece cable: 2.000mm
Tank capacity: 300ml
Temperatures:
Operating: +10°C to +40°C
Storage: -20°C to +70°C
Humidity:
Operating: 30% to 75%
Storage: 10% to 100% including condensation
Atmospheric pressure:
Between 500 hPa and 1060 hPa
IV - -INSTALLATION / FIRST USE

4. 1 UNPACKING THE DEVICE

Upon receipt of the device, check for any damage caused in transit.
Contact your supplier if necessary.
4. 2 RECOMMENDATIONS
Have your device connected to the electric supply by a certified dental installation technician.
The device's electrical connections must be in compliance with current standards. A grounded power
socket must be used.
4. 3 INSTALLATION
Important:
Never rotate the handpiece connector on its cord, otherwise you may damage the device.
Do not place the device close to or on top of another device.
Do not place the power cord and the footswitch cord in a wire cover or in a cable gland.
- Place the control unit in position on a fixed, horizontal surface, or with a slope of no more than 5°.
- Check that the power control dial is on OI (stop).
- Connect the power cord to the power receptacle of the device.
- Connect the power cord to a socket with a ground pin.
- Position the footswitch so that it is easily accessible for your feet.
- Check that there is no humidity in the handpiece connections. If there is, dry it out by wiping, then
blowing with the multifunction syringe.
- Connect according to model:
• the S N (P5 N XS) handpiece to the cord connector, by lining up the electrical
UPRASSON EWTRON EWTRON
contacts, taking care not to twist the two parts;