Physical Description - Satelec P5 Newtron XS Gebrauchsanleitung

- To unplug the power cord, grip the cord plug and hold the wall socket.
- Never fill the irrigation solution tank while it is placed on the device.
- Do not fill the irrigation solution tank beyond the level indicated by the border of the tank.
- When the device is not to be used for a long period of time, rinse thoroughly, then unplug the device
from the electric supply.
- Do not attempt to move the device during use.
Environment:
- Do not cover the device or obstruct the ventilation vents.
- Do not immerse the device in liquid, and do not use it outdoors.
- Do not tilt the device at an angle greater than 5°.
- Do not place the device near a heat source.
- Make sure that the cords are not in the traffic path.
- The device should be stored in its original packaging in a safe place.
- The device is not designed for use in the presence of anesthetic gases or any other flammable gas.
- Do not expose the device to water vapor, or splashes.
- Any condensation inside an electrical device is a potential hazard.
- If the device needs to be taken from a cold area to a hot area, allow it to reach room temperature
before use.
- The device is not designed to work near ionizing radiation.
- Do not insert metal objects into the device (risk of electric shock, short-circuit or emission of
hazardous substances).
Maintenance:
- The device must be rinsed before and after each use with distilled or demineralized water.
- To avoid any reaction between different irrigation solutions which may be used (crystallization,
precipitation, etc.), the irrigation solution tank and irrigation circuit must be rinsed with distilled or
demineralized water each time the irrigation solution is changed.
Accessories:
- The device has been designed and developed with its accessories to meet maximum standards of
safety and performance
- The use of any other manufacturer's accessories presents a potential hazard for the practitioner, the
patient and the device.
Repair:
- Do not repair or modify the device without prior authorization from SATELEC.
- In the case of a fault, contact the supplier of your device. Do not use unauthorized repairers, who
might make your device dangerous for you and your patients.
If you have any doubt, contact an approved dealer or the SATELEC customer support department:
- www.acteongroup.com
- E-mail: satelec@acteongroup.com.
III - DESCRIPTION

3. 1 PHYSICAL DESCRIPTION

The device is composed of five elements:
- a control unit (Fig. 1-1),
- a footswitch (Fig. 1-2),