Troubleshooting - Vitek VT-1693 Betriebsanweisung

port regularly; wipe bottom of the operat-
ing chamber of the oven.
• Wash glass tray and rolling ring with neu-
tral soapy solution.
• Do not immerse hot glass tray into water,
it could be broken because of sudden
temperature drop.
MALFUNTIONS AND TROUBLE SHOOTING
Normal operation
Microwave oven inter-
feres with reception of
TV or radio signals.
Low intensity of back-
light
There is steam conden-
sation on the door, hot
air is going out of the
ventilation outlets.
Microwave oven is
switched on without any
foodstuff loaded in.
Trouble shooting
Problem
Oven cannot be turned on
There is no heating
Rolling glass tray issues
strange noise during opera-
tion
In case the malfunction is still there, apply to a service center, do not try to repair or adjust
the oven on your own.
Delivery set
Microwave oven – 1 item
Glass tray – 1 item
Roller ring – 1 item
Grill grating – 1 item
1693.indd 13 1693.indd 13
Interference with reception of TV or radio signals could appear during
microwave oven operation. Similar interferences appear while operations
of small electrical appliances like mixer, vacuum cleaner and hair dryer.
This is normal.
If low power level of microwave radiation is set on, intensity of backlight
could be low. This is normal.
While cooking water is vaporized out of foodstuff, most of the steam is
released through ventilation outlets, but some steam could condensate
on the inner side of the door. This is normal.
Switching microwave oven for short time without any foodstuff loaded in
would not result in any malfunction. Always check if there is any foodstuff
inside the operating chamber before switching on.
Possible cause
Power cord plug is not inserted in
wall outlet
Wall outlet's malfunction
Door is closed not tightly
Rolling ring or lower part of oper-
ating chamber is dirty
13
ENGLISH
• To remove unpleasant odors out of the
operating chamber put cup of water with
a little bit of lemon juice inside and boil
the water for several minutes. Wipe walls
of the chamber with soft cloth very care-
fully.
Unplug power cord from wall out-
let. After 10 sec insert it back.
Try connecting another appliance
to the same wall outlet for control
Close the door tightly
Detach glass tray and rolling ring.
Wash rolling ring and bottom of
operating chamber.
Removal
12.03.2008 17:33:22 12.03.2008 17:33:22