Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing washer in
position on the sink.
3.
Slip the plastic washer, the slide washer, the metall
washer and collar nut over the hose and threaded
base and tighten the collar nut by hand. If there is
not enough space, please use only the slide washer
and the metall without the
4.
Tighten screws.
5.
Connect the connecting hose to the angle valves;
cold right - hot left.
6.
Connect the hose with hose nut, taper sleeve, disc
and washer.
7.
Mount the hose weight - be careful by the max.
drawn out, otherwise the hose could be crack.
8.
After the assembly!
9.
Dismount the handspray and the filter.
10.
Flush through the hose.
11.
Cleaning the filter.
12.
Mount the filter and the handspray
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
The handspray can be drawn approx. 50 cm out of the
arm lining. The spray mode is changed to showerspray by
pressing the front button
By pressing the rear button
the spray mode changes to aerated spray.
If the waterflow drops, clean the filter located between
hose and handspray.
on the top of the sprayhead.
or switching off the water,
English
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature: 65° C
Rate of flow by 0,3 MPa aerated spray: 6,4 l/min
Rate of flow by 0,3 MPa shower spray: 6,4 l/min
Back flow and vacuum breaker
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 6.
No adjustment is necessary when using a continuous flow
water heater.
Spare parts (see page 3)
1
handle
1.1 screw cover
flange
2
3
nut
4
cartridge cpl.
5
locking screw
6
hose 1,25 m
7
handspray assy
8
aerator cpl. (10)
9
fixation set
10
non return valve
11
non return valve
12
connection hose 800 mm
13
filter
max. 1 MPa
0,15 - 0,5 MPa
1,6 MPa
max. 80° C
14890000
96338000
96391000
94194000
92730000
96059000
95048000
14893003
13955000
95319000
95332000
95333000
97489000
97735000
Werbung
Inhaltsverzeichnis
