Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Setting the Spotlight into Operation
GB
WARNING To prevent damage to your eyes,
never look directly into the light
source for a long time.
Please note that fast changes in
lighting, e. g. flashing light, may trig-
ger epileptic seizures with photosen-
sitive persons or persons with
epilepsy!
Connect the mains cable provided to the mains
jack (5) first, then connect it to a socket (230 V~/
50 Hz). Thus, the spotlight is ready for operation.
Operate it via a DMX light controller (
or on its own using the automatic control program
adjusted (chapter 7). To switch off, disconnect the
mains plug from the socket.
For a more convenient operation, it is recom-
mended to connect the unit to a mains socket
which is switched on and off via a light switch.
Caution: Never connect the unit to the mains volt-
age via a dimmer!
6
Operation
The settings of the spotlight are made via a system
menu to be operated via the buttons (2) and the dis-
play (1). After switching on the power supply, the
display shows the last setting made.
The buttons have the following functions:
– Button ESC / MENU to return to the higher menu
level
– Buttons UP and DOWN to select a menu item
and to set values or menu options
– Button ENTER to activate the menu item and to
go to the next parameter
The menu structure can be found in chapter 10.2.
Use the buttons to make the desired settings for the
corresponding operating mode according to chap-
ters 7 to 9. The display is switched off a few
seconds after the last button was pressed; it is
switched on again when a button is pressed.
Important: To make sure that a setting remains
memorized when the power supply is switched on
again, wait for 10 seconds after making the setting
before exiting the submenu. (When the setting is
being memorized, the display will briefly flicker.)
12
7
7.1 Automatic mode
The unit offers two automatic show programs.
"Auto 1": colour sequence with crossfading
"Auto 2": stroboscope
To activate one of these programs:
1) Press the button ESC / MENU repeatedly until
you enter the main menu.
2) Select the option
button UP or DOWN.
chapter 8)
3) Press the button ENTER: The last program
adjusted (
on the display. Select one of the two programs
with the button UP or DOWN.
4) To change the speed, press the button ENTER:
The current speed is shown. Select one of the 9
speeds
DOWN.
7.2 Music control
For music control of the spotlight via its microphone
(6) two music modes are available:
"Sound 1": all LEDs lighting up at the same time by
"Sound 2": LEDs lighting up with changing colours
1) Press the button ESC / MENU repeatedly until
you enter the main menu.
2) Select the option
button UP or DOWN.
3) Press the button ENTER: The last music mode
adjusted (
shown on the display. Select one of the two
modes with the button UP or DOWN.
7.3 Floodlight mode
For radiating a single colour continuously, the spot-
light offers nine preset colours and one colour to be
individually adjusted.
1) Press the button ESC / MENU repeatedly until
you enter the main menu.
2) Select the option
the button UP or DOWN.
Operation without DMX Controller
in the main menu with the
or
to
music control
by music control
in the main menu with the
oder
) is activated and shown
with the button UP or
) is activated and
in the main menu with
Werbung
Inhaltsverzeichnis
