Mulching With The Mulching Insert [4757 Li Sp, 4757 Li Vs] (12, 13); Mowing With Side Discharge [4757 Li Sp, 4757 Li Vs] (14); Checking The Charge Status Of The Rechargeable Battery; Work Instructions - Solo AL-KO 4237 Li P Betriebsanleitung

Work instructions

6.7 Mulching with the mulching insert [4757
Li SP, 4757 Li VS] (12, 13)
When mulching, the cuttings are not collected but
remain on the lawn. The mulch protects the
ground from drying out and supplies it with nutri-
ents. The best results are achieved through regu-
larly cutting back by approx. 2 cm. Only new
grass with soft leaf tissue rots quickly.
■
Grass height before mulching: max. 8 cm
■
Grass height after mulching: min. 4 cm
NOTE
Adjust the stepping speed of the mulch-
ing, do not go too quickly.
Installing the mulching insert
CAUTION!
Danger of lacerations
Danger of lacerations when reaching in-
to the running mower mechanism.
■
Only install or remove the mulching
insert when the motor and mower
mechanism have stopped.
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Unhook the grass collector see chapter 6.6
"Mowing with grass collector (10, 11)",
page 36.
3. Lift the baffle (12/1) and insert the mulching
insert (12/2) in the discharge channel (12/3)
(12/a). The locking mechanism must engage.
IMPORTANT!
Danger of damage to the appliance
If the mulching insert does not engage,
the mulching insert and mower mecha-
nism can be damaged.
■
Make sure that the locking mecha-
nism engages.
Removing the mulching insert
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Lift the baffle.
3. Release the locking mechanism (13/1) on the
mulching insert (13/a).
4. Pull out (13/b) the mulching insert (13/2).
456877_c
6.8 Mowing with side discharge [4757 Li SP,
4757 Li VS] (14)
CAUTION!
Danger of lacerations
Danger of lacerations when reaching in-
to the running mower mechanism.
■
Only install or remove the side dis-
charge insert when the motor and
mower mechanism have come to a
standstill.
Installing the side discharge insert
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Remove the grass collector.
3. Press the release lever (14/1) of the cover
flap (14/a).
4. Fold out the cover flap (14/2) of the side dis-
charge and keep hold of it (14/b).
5. Install (14/c) the side discharge insert (14/3).
6. Slowly close the cover flap (14/2). The cover
flap secures the side discharge insert against
falling out.
Removing the side discharge insert
1. Switch off the appliance: Turn the safety key
to 0 and remove it.
2. Fold out the cover flap (14/2) of the side dis-
charge and keep hold of it (14/b).
3. Remove (14/c) the side discharge insert
(14/3) and close the cover flap (14/2).
6.9 Checking the charge status of the
rechargeable battery
NOTE
How to determine the charge status is
described in the operating instructions
for the rechargeable battery.
7 WORK INSTRUCTIONS
Heed the safety instructions (see chapter 3.9
"Safety instructions relating to operation",
page 34).
NOTE
Comply with the local regulations as to
when a lawnmower can be operated.
■
Watch out for objects in the grass and re-
move them from the working area.
■
Only mow when visibility is good.
37