Makita 4326 Bedienungsanleitung Seite 8

(2) Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
(3) As the blade pierces the workpiece, slowly
lower the base of the tool down onto the
workpiece surface.
(4) Complete the cut in the normal manner.
Finishing edges
Fig.16
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting metal.
Failure to do so will cause significant blade wear. The underside of
the workpiece can be greased instead of using a coolant.
Dust extraction
Fig.17
Clean cutting operations
connecting this tool to a Makita vacuum cleaner. Insert
the hose of the vacuum cleaner into the hole at the rear
of the tool. Lower the dust cover before operation.
NOTE:
Dust extraction cannot be performed when making
•
bevel cuts.
Rip fence (optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before
accessories.
1. Straight cuts
Steel base type
008096
When repeatedly cutting widths of 160 mm or less, use
of the rip fence will assure fast, clean, straight cuts.
Aluminum base type
008097
can be performed
installing or removing
1. Rip fence (Guide
rule)
1
1. Rip fence (Guide
rule)
1
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
secure it.
2
3
002776
Aluminum base type
1
by
2
005454
2. Circular cuts
2
3
002777
Aluminum base type
4
005455
Steel base type
1
008098
8
1. Hex wrench
Steel base type
2. Bolt
3. Rip fence (Guide
1
rule)
4. Guide facing
4
1. Bolt
2. Fence guide
3. Hex wrench
4. Rip fence (Guide
rule)
3
4
1. Treaded knob
Steel base type
2. Guide facing
3. Rip fence (Guide
rule)
4. Pin
1
4
1. Threaded knob
2. Pin
3. Rip fence (Guide
rule)
4. Fence guide
1
2
3
1. Rip fence (Guide
rule)