Assembly - AL-KO Snow Line 620E III Betriebsanleitung

Snow Line 620E III

Assembly

Caution!
Do not operate the machine until it has
been fully assembled.
Required tools
„ 2 Open-end or ring spanners, size 10
„ Open-end or ring spanner, size 13
„ Hex key, 5 mm
„ Combination or needle nose pliers
„ Screwdriver
„ Spray oil
„ Tyre pump with pressure gauge (auto tyre valve)
Assembly sequence
Mounting the control panel
1. Secure by using 3 screws (
2. ( 1-2) Leave this hole free for guiding the
hand crank.
Screwing together and adjusting the control cables
Wheel drive and auger drive.
1. Turn the adjuster on the control cable in the
direction of the arrow (
trol cable no longer sags (is slightly tensi-
oned). Hold the cable while tightening so that
it does not twist.
2. Tighten the lock nut(
3. 620E III 3 control cables
x The control cables are installed.
Screwing together the rods for the speed selector
lever
1. Attach the rods to the housing at the bottom.
(
3-1).
469370_a
1-1).
2-2) until the con-
2-1) firmly.
Mounting the lever for speed selection and snow
discharge height
1. Place the spring washers (
reads.
2. Screw on the snow discharge height lever (
4-2) and tighten
3. Screw on the speed selector lever (
and tighten.
Connecting the heating and headlight connector
1. Connect the clip connector from the heating
and headlight (
Attaching the snow discharge chute
1. Lightly lubricate the surface of the snow di-
scharge chute that slides against the snow
blower with spray oil (
2. Mount the snow discharge chute (
3. Insert mounting screws from inside dint flaps
and snow discharge chute (
4. Tight the snow discharge chute with the self-
locking nuts .
x The snow discharge chute is attached.
Securing the control cable to the snow discharge
flap
1. Attach the control cable in the guide (
8-2).
2. Tighten the lock nut (
4-1) on the th-
4-3)
5-1).
6).
7-1).
7-2).
8-2).
GB
8-1,
25