Specifications; Safety Instructions - Makita LC1230 Betriebsanleitung

ENGLISH
1 Base
2 Wrench holder
3 Hook
4 Bolt
5 Center cover
6 Hex bolt
7 Safety cover (Safety guard)
8 Socket wrench
9 Shaft lock
10 Hex bolt
11 Spindle

SPECIFICATIONS

Model
Blade diameter ........................................................................................................................................305 mm
Hole (arbor) diameter .............................................................................................................................25.4 mm
No load speed (RPM) ................................................................................................................................. 1,300
Dimensions (L x W x H) ............................................................................................ 516 mm x 306 mm x 603 mm
Net weight ................................................................................................................................................19.0 kg
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse
effects to the operation of other equipment. With a
mains impedance equal or less than 0.25 Ohms it
can be presumed that there will be no negative
effects. The mains socket used for this device must
be protected with a fuse or protective circuit breaker
having slow tripping characteristics.
Explanation of general view
12 Inner flange
13 Carbide-tipped saw blade
14 Outer flange
15 Lever
16 Loosen
17 Tighten
18 Vise stop
19 Indicator
20 Graduation
21 Vise plate
22 Vise nut
115 mm
90 mm

SAFETY INSTRUCTIONS

Warning! When using electric tools, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury,
including the following. Read all these instruc-
tions before attempting to operate this product
and save these instructions.
For safe operation:
1.
2.
3.
4.
5.
23 Vise handle
24 Angle
25 Channel
26 Lever
27 Lock-off button
28 Handle
29 Switch trigger
30 Dust box
31 Limit mark
32 Screwdriver
33 Brush holder cap
100 mm x 100 mm
Keep work area clean
Cluttered areas and benches invite injuries.
Consider work area environment
Don't expose power tools to rain. Don't use
power tools in damp or wet locations. Keep work
area well lit. Don't use power tools in presence of
flammable liquids or gases.
Guard against electric shock
Prevent body contact with grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators).
Keep children away
Do not let visitors contact tool or extension cord.
All visitors should be kept away from work area.
Store idle tools
When not in use, tools should be stored in dry,
high, or locked-up place, out of the reach of chil-
dren.
LC1230
75 mm x 150 mm
85 mm x 85 mm
5