Fold Up The Wheelchair; Taking Off The Wheels; Push Bar - Vermeiren Eclips X4 KIDS Gebrauchsanweisung

2.11 Fold up the wheelchair

L CAUTION:
Chance of pinching – Do not place fingers between the components
of the wheelchair.
1. When the push bar is available remove the push bar.
2.
Fold or remove the footplates (see § 2.4).
3. Take the seat on the front side and backside and pull it up.
4. Push on the handgrips to fold up the wheelchair further.

2.12 Taking off the wheels

To facilitate the transport off the wheelchair the rear wheels can be taken off:

2.13 Push bar

L WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L WARNING:
Risk of injury - When equipped with the push bar, the push bar shall
always be mounted (→ to increase the stability of the backrest).
Your wheelchair can have a push bar. The push bar increase the stability of the backrest and
offer you the possibility of pushing the wheelchair by an attendant. To do this, use the pre-
mounted handgrips.
As there are different push bars for different seat widths, take care that no tension between
the handgrips of the back tubes is created.
The mounting of the push bar is done as follows:
To take off the push bar:
1. Loosen the Philips screw  on the right handgrip.
2. Remove the hook from the right handgrip.
1. Make sure the brakes standing in the off
position.
2. Take the wheelchair to the side frame where
you want to remove the wheel.
3. Press the button
hub.
4. Pull the wheel away from the frame.
1. Secure the push bar  by fastening the left side
to the end of back tube handgrip  with the
Philips screw  in the applicable sunk threads.
2. Screw gently the Philips screw  on the right
hand side into the thread of the back tube.
3. Swing the push bar to the right.
4. Hook the suspension of the push bar  over the
screw thread.
Use the two holes on the left handgrip to adjust
the tension of the backrest.
Page 11
Eclips X4 kids

in the center of the wheel
2016-01