Installation - Kärcher HD 9/100 Cage Adv Original Bedienungsanleitung

Push handle
1
Filter key
2
Hose/cable holder
3
Filter venting screw
4
Operating hours counter
5
High-pressure connection (Classic version)
6
Water shortage safeguard
7
Advance pressure pump venting screw (option)
8
Accessory compartment
9
Pressure gauge
10
Safety valve
11
Thermostat valve
12
High-pressure connection (Advanced version)
13
Type plate
14
Parking brake pedal
15
Filter
16
Mains connection cable with mains plug
17
Water connection
18
Power switch
19
Water shortage indicator lamp
20
Operating state indicator lamp
21
Oil drain plug
22
Oil level display
23
Oil filler neck
24
Venting lever
25
Advance pressure pump (option)
26
Spray lance storage
27
Lashing eyelet
28
Attachment point for catching fixture
Crane loading brace
29
High-pressure gun storage compartment
30
Bypass pipe (dump gun, Classic version)
31
Spray lance
32
High-pressure nozzle
33
Union nut
34
Trigger
35
Safety latch
36
High-pressure gun (dry shut, Adv version)
37
High-pressure gun (dump gun, Classic version)
38

Installation

Fitting the venting screw
1. Unscrew the transport screw.
2. Screw in and tighten the venting screw supplied.
1. On 60 Hz version devices, attach a suitable mains
plug to the mains cable. The mains plug may only be
attached by a qualified electrician.
Check the oil level
1. Position the device on a level surface.
2. The oil level must be in the middle of the oil level dis-
play.
3. Top up with oil if necessary (see "Technical data")
Maximum pressure screw connection
This system establishes the connection between the
spray lance and high-pressure gun and also between
the spray lance and nozzle.
1. Screw the pressure ring far enough onto the spray
lance or hose connection so that approximately 2
thread turns are visible before the pressure ring.
Note: The pressure ring has a left-hand thread.
1
High-pressure connection
1
2 thread turns visible
2
Pressure ring, left-hand thread
3
Pressure screw
4
Spray lance
5
2. Fit the spray lance with pressure piece into the high-
pressure connection.
3. Push the pressure screw onto the pressure ring.
4. Screw in and tighten the pressure screw (tightening
torque 160 Nm).
Installing accessories
Install accessories only when the device is switched off.
Do not exceed the maximum tightening torque of 20 Nm
when tightening the screw connections.
1. Connect the spray lance to the high-pressure gun.
2. Connect the high-pressure hose to the high-pres-
sure gun. Maximum hose length 40 m, DN 6.
3. Connect the high-pressure hose to the high-pres-
sure connection.
4. Fit the nozzle holder onto the spray lance.
5. Insert the nozzle into the nozzle holder.
6. Screw on the union nut and hand-tighten.
High-pressure hose catching fixture
1. Secure the high-pressure hose on the high-pressure
gun.
English
60 Hz version
2 3 4 5
13