Technical Specifications - Grundig CDP75 Bedienungsanleitung

CDP 75 / CDP 110
Maintenance
Maintenance
• The lens X of the CD player should never be touched!
• Do not expose the CD player, batteries or CDs to rain and
dampness, sand and dust or to excessive heat caused by hea-
ting equipment, or to direct sunlight, for example inside a car
parked in the sun.
• The lens may cloud over when the set is suddenly moved from
cold to warm surroundings. Playing a CD is then not possible. Leave the CD player in a
warm environment until the moisture evaporates.
• Always pick up the CD by the edge and put it back
in its box after use.
• To clean the CD, wipe it off in a straight line from the center
towards the edge using a soft, lint-free cloth.
A cleaning agent may damage the disc!
• You can clean the CD player with a soft and slightly dampened
chamois leather. Do not use any cleaning agents
as they may have a corrosive effect.
• When a newly purchased CD does not stay on the hub, this is
caused by small burrs around the center hole of the CD.
Remove the burrs by rubbing the edge of the center hole with a
pen or other such instrument.

Technical specifications

Frequency response................20-20,000 Hz
D/A conversion .......................1 bit
General
Power Supply..........................AC: using the AC adaptor 230 V
DC: 4 LR 6 (AA) alkaline batteries or rechargeable batteries
Power consumption: ...............1.0 W DC
Dimensions (wxhxl) ................Approx. 132 mm x 32 mm x 158 mm
Weight: ...................................Approx. 300 g (10 oz)
Supplied accessories: .............Headphones (in-ear-type)
NR 60-2 – mains adapter
Pouch to protect the CD player when carrying around.
Remote control.
4 x rechargeable NiCd batteries
Troubleshooting
Troubleshooting
CD play does not start or interrupts
Display: no indication ERROR or NO DISC
– CD lid is not securely closed
• Close the lid securely
– HOLD feature is activated
• Switch off the HOLD feature
– Moisture condensation
• Leave the player in a warm place until the moisture evaporates
– CD is not or incorrectly inserted
• Insert a CD, label facing up
– CD is badly scratched
• Use another CD
– CD is dirty
• Clean the CD
No sound or bad sound quality
– PAUSE is activated
• Press PLAY/PAUSE 2;
– Loose or wrong connections
• Check connections
– Volume is not turned up
• Adjust the volume
– Headphones worn the wrong way round
• Pay attention to the L (left) and R (right) indications
– Headphone plug is dirty
• Clean the headphone plug
– Strong magnetic fields near the CD player
• Change the players position or connections
– Electrostatic discharge from the user via the CD player
• Press PREV ∞ or NEXT § once or pess PLAY/PAUSE 2; twice
Malfunctions with remote control operation
– Remote control is not firmly connected to the REMOTE p socket
• Check connections
GRUNDIG Service
Troubleshooting
Troubleshooting
If a fault occurs, please check the points listed below before taking your set for repair.
X
If you are not able to remedy a problem by following these hints, consult your dealer or
service facility.
Under no circumstances should you try to repair the set yourself, as this would invalidate
your guarantee.
Problem
– Possible cause
• Remedy
No power or no CD play start
Display: no indication
Batteries
– Batteries incorrectly inserted
• Insert the batteries correctly
– Use of new batteries
• Press PLAY/PAUSE 2;
– Batteries are empty
• Change/recharge the batteries
– Contact pins are dirty
• Clean them with a cloth
AC power adapter
– Loose connection
• Connect the adapter securely
Lid of CD player does not open
– HOLD feature is activated
• Switch off the HOLD feature
Play does not start from the first track
– RESUME , SHUFFLE or PROGRAM is activated
• Switch off RESUME, SHUFFLE or PROGRAM
Allgemeiner Teil / General Section
1 - 11