Chapter I. Installing The Scanner; Software Installation Requirements; Hardware Requirements - Plustek MobileOffice S400 Benutzerhandbuch

Chapter I. Installing the Scanner

Before installing your scanner, please verify that you have all of the proper
components. A list of the package contents is provided in the Box Contents section of
this guide.

Software Installation Requirements

Your scanner comes with the OCR software (ABBYY FineReader Sprint),
Business card Recognition
management software (NewSoft Presto! PageManager), the scanner's driver,
DocAction, and the image capture software (Plustek DI Capture). All of these software
applications use approximately 800 megabytes of hard disk space after they are
installed into your computer. To ensure ample room for the installation, as well as for
scanning and saving images, a minimum of 1 GB of hard disk space is recommended.
This USB scanner can only operate under the Microsoft Windows 2000
Professional/ XP/ Vista/ 7 operating system.

Hardware Requirements

This scanner connects to your computer through the Universal Serial Bus (USB),
which supports hot swap. To determine whether your computer is USB-capable, you
must check the rear of your PC to locate a USB jack that looks the same as the one
pictured below. Note that on some computers, the USB port at the rear of the computer
may be occupied and additional ports may be found on the monitor or keyboard. If you
are having trouble in locating the USB port on your computer, please refer to the
hardware manual that came with your computer.
Upon examination, you should find one or two rectangular USB ports, which
usually appear as shown below.
If you don't find such USB ports on your computer, then you need to purchase a
certified USB interface card to add USB capabilities to your computer.
Software (HotCard
USB Connector(s)
6
BizCard Finder), document