Calibrating The Scanner; Power Save; Using The Wall Holder - Plustek MobileOffice S400 Benutzerhandbuch

Calibrating the Scanner

Calibrate the scanner if colors appear in areas that should be white, or colors of
the scanned image and the original vary a lot. This allows you to adjust and
compensate for variations that can occur in the optical component over time by its
nature.
The following describes how to calibrate the scanner:
1. Insert the special calibration sheet face down into the page feed slot of the
scanner.
Attention
2. Click Start > All Programs > Your scanner model name > Calibration
Wizard.
3. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now....
4. Click on the Start button to begin the calibration process.
5. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then
click Finish.

Power Save

To save power consumption, when the scanning process is finished, the scanner
light source will turn itself off and the scanner will enter a lower-power mode without
delay time.

Using the Wall Holder

Please insert the special calibration sheet
included with the scanner. Alternatively you may
also use any plain white sheet of paper sized in
Letter size (8.5" x 11.69") instead; however, the
calibration effect may be less good than the
special calibration sheet.
20