Zanussi ZFU719EW Benutzerinformation Seite 35

Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally,
however, the appliance should not be posi-
tioned below overhanging wall units. Accurate
levelling is ensured by one or more adjustable
feet at the base of the cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so
that the shelves can be removed.
Warning!
1. Remove the plug
from the power sock-
et.
2. Tilt back the appli-
ance carefully so that
the compressor can-
not touch the floor.
3. Unscrew both ad-
justable feet.
4. Unscrew the
screws of the door
bottom hinge.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
www.zanussi.com
2
1
5. Take off the appli-
ance door by pulling it
slightly downwards.
6. Unscrew the top
door hinge pin of the
appliance then screw
it back on the other
side.
7. Fit the appliance
door on the upper
door hinge pin.
min.
100 mm
15 mm 15 mm
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door,
do these steps:
8. Remove the lower
hinge. Put over the pin
in the direction of the
arrow.
9. Unscrew and install
the screw on the op-
posite side.
10. Install the lower
hinge on the opposite
side leaving the posi-
tion of the door un-
changed.
11. Screw in the one
screw in the place set
free on the other side
as well as the adjusta-
ble feet (2 pieces).
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of
the gasket.
12. Remove and install
1)
the handle on the
opposite side.
13. Reposition, level
the appliance, wait for
at least four hours and
then connect it to the
power socket.
35