Specifications - Makita HR1830 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Lamp
3-1. Reversing switch
4-1. Action mode changing knob
5-1. Grip base
5-2. Side grip
5-3. Loosen
5-4. Tighten

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
5-5. Teeth
5-6. Protrusion
6-1. Bit shank
6-2. Bit grease
7-1. Bit
7-2. Chuck cover
8-1. Bit
8-2. Chuck cover
9-1. Depth gauge
Model
Concrete
Core bit
Diamond core bit (dry type)
Steel
Wood
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 86 dB(A)
pA
) : 97 dB(A)
WA
ENE042-1
Vibration
The vibration
determined according to EN60745:
Work mode : hammer drilling into concrete
Vibration emission (a
ENF002-2
Uncertainty (K) : 1.5 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
ENG905-1
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
3
9-2. Hole of grip base
9-3. Loosen
9-4. Tighten
10-1. Dust cup
11-1. Blow-out bulb
12-1. Keyless drill chuck
12-2. Chuck adapter
13-1. Sleeve
13-2. Ring
HR1830 / HR1830F
18 mm
35 mm
65 mm
13 mm
24 mm
0 - 1,500
0 - 5,000
279 mm
1.9 kg
/II
total value (tri-axial
2
) : 14 m/s
h,HD
2
2
) : 2.5 m/s
h,D
2
ENG900-1
vector sum)
or less
ENG901-1