Technical Data; Cleaning - Becker Centronic MemoControl MC42 Bedienungsanleitung

Deleting the intermediate positions
1. Press the intermediate position programming button ▼ for longer than 5 seconds. The
intermediate position has now been deleted.
The control light will flash briefly three times.
Programming the ventilation/reverse position
Prerequisite: the roller shutter / blind is at the lower end limit.
1. Press and hold the ventilation/reverse position programming button ▲.
2. Press the UP button at the same time until you have reached the required ventilation/
reverse position. Adjustments can be made using the UP button or DOWN buttons.
3. Release the ventilation/reverse position programming button ▲. The ventilation/re-
verse position has now been saved.
The control light will flash briefly three times.
Deleting the ventilation/reverse position
Press the ventilation/reverse position programming button ▲ and hold for longer than 5
seconds. The ventilation/reverse position has now been deleted.
The control light will flash briefly three times.
Nominal voltage
Switched current
System of protection
Protection class
Permissible ambient temperature
Type of installation
Clean the device with a damp cloth only. Do not use a cleansing agent as this may
damage the plastic.

Technical data

230-240 V AC / 50-60 Hz
5 A /250 V AC for cos ϕ =1
IP 20
II
0 to +55 °C
Concealed Ø 58 mm wall-mounted.
Exposed in appropriate exposed casing.

Cleaning

22
Operating Instructions