Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
Explanations
Manual/Automatic sliding switch
When the sliding switch is switched to MAN, only manual control commands are carried
out (e.g. by pressing the UP, STOP and DOWN buttons).
When the sliding switch is switched to AUTO, automatic control commands are carried
out (e.g. switching time).
Control light
Acknowledges that the switching times have been set by flashing 3 times.
Selecting roller shutter or venetian blind
Either the roller shutter or venetian blind mode can be set using the encoding switch on
the back of the device.
When the roller shutter function is used, the roller shutter remains locked after a control
button has been activated.
RESET button
When the RESET button is pressed (with a ballpoint pen or similar), all switching times,
intermediate position and ventilation/reverse position are deleted.
Intermediate position
The intermediate position is a position of the roller shutter/venetian blind between the
upper and lower limits and can be freely selected. This position can also be reached from
the upper position after programming.
Press the DOWN button twice in rapid succession to move to the intermediate position.
Ventilation/Reverse
The ventilation/reverse position is a position of the roller shutter/venetian blind between
the upper and lower limits and can be freely selected. Using this function, you can raise
the shutter from the lower end limit until the ventilation slits are open. In the case of
venetian blinds, the slats will be opened.
Press the UP button twice in rapid succession to move to the ventilation/reverse posi-
tion.
19
Quicklinks ausblenden:
Werbung
Kapitel
