Becker Centronic MemoControl MC42 Bedienungsanleitung Seite 18

Warning
• Risk of injury by electric shock.
• Terminals must be connected by an authorised electrician!
• If more than one drive is controlled using the MC42, the drives must be
decoupled by relay controls. This decoupling is not applicable to Becker drives
with electronic limit stop.
• Always observe the switched current of the device.
1. Connect the power supply unit to the MC42 as follows:
PE
N
L
2. Put the protective caps back on the power supply unit.
3. Fix the power supply unit in the box.
4. Put the operating device in the frame and plug it into the power supply unit.
Tubular drive
Green/yellow
Blue
Brown/black
Black/brown
18
Operating Instructions