Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
Encoding switch setting:
Lower position ➔ Roller shutter mode
Programming the daily switching times
To set the desired UP switching time, press the UP button for at least 6 seconds. The
transmission control light flashes briefly three times. This control command will now be
repeated every 24 hours.
To set the desired DOWN switching time, press the DOWN button for at least 6 seconds.
The transmission control light flashes briefly three times. This control command will now
be repeated every 24 hours.
Deleting the daily switching times
In order to delete the UP and DOWN switching time, press the reset button.
Note
When the reset button is pressed (with a pen, for instance), all switching times,
intermediate positions and turning /ventilation positions are deleted.
Programming the intermediate position
Prerequisite: the roller shutter / venetian blind is at the upper end limit.
1. Press and hold the intermediate position programming button ▼.
2. Press the DOWN button at the same time until you have reached the required inter-
mediate position. Adjustments can be made using the UP button or DOWN buttons.
3. Release the intermediate position programming button ▼. The intermediate position
has now been saved.
The control light will flash briefly three times.
Factory setting
Programming
21
Quicklinks ausblenden:
Werbung
Kapitel
