Operation - D&H DH05C Anleitung

103 Version number
104 Date
105 Revision number
106 Date
10.3

Operation

Put the locomotive on the programming track und read out the locomotive address of the decoder
(par001+par002). The default value should be 1001. Program the desired locomotive address and start
running the locomotive keeping the other parameters values. After the first check you can vary the
parameters of the engine freely according to your requirements.
In case your programming device indicates "error", please check again the correct wiring of the locomotive
and pay attention to the wiring instructions of the programming track. Never put such a locomotive into
operation!
(Read only)
(Read only)
(Read only)
(Read only)
37