Setup Features - D&H DH05C Anleitung

8.2

Setup Features

The characteristics of a locomotive operated in the DCC-operating mode can be varied by programming the
configuration variables (CV) freely at any time. The programming procedure is described in the instructions
of your programming device.
Notice:
In case the speed steps programmed on the decoder differ from those of the control device,
malfunctions may occur. Please pay attention to the respective information concerning your digital
system.
List of supported CV:
CV Name and definition
01 Short address
02 Starting voltage
03 Acceleration time
The value corresponds to the time in seconds from start to maximum speed
04 Deceleration time
The value corresponds to the time in seconds from maximum speed to stop
05 Maximum speed
07 Version number
08 Manufacturer identification
97 = Doehler & Haass (Decoder Reset with "8")
09 Motor frequency
0 = 32 kHz, 1 = 16 kHz, 2 = low-frequency
(See supplement 2)
(Read only)
(Read only)
18
Range
0 – 127 (3)
0 – 15 (0)
0 – 255 (3)
0 – 255 (3)
0 – 127 (92)
0 – 2 (1)