Operation; Explication Of The Signal-Stopping Sections - D&H DH05C Anleitung

7.3

Operation

Put the locomotive on the programming track und read out the programming parameters of the decoder.
The default value should be 01-532. Program the desired locomotive address and start running the
locomotive keeping the other parameter values. After the first check you can vary the parameters of the
engine freely according to your requirements.
In case your programming device indicates "error", please check again the correct wiring of the locomotive
and pay attention to the wiring instructions of the programming track. Never put such a locomotive into
operation!
7.4

Explication of the signal-stopping sections

One-part signal-stopping section:
In front of the signal one track section is supplied by a diode. The decoder must be programmed for
one-part stopping section (-). The locomotive will be braked to a halt.
Two-part signal-stopping section:
In front of the signal there are two track sections. The first one is supplied by a diode and the
locomotive will be braked down to internal speed step 3 in this section. The second one is without
supply and the locomotive will stop just in front of the signal. The decoder must be programmed for
two-part stopping section (=).
16