D&H DH05C Anleitung Seite 72

Short-Mode
 After changing in programming mode the decoder is in short-mode.
The engine lighting flashes slowly and periodically.
 Enter now the number of the CV you want to change e.g. 01 (double-digit).
 Activate the reversion of the driving direction for confirmation. Lighting is now flashing shortly two times.
Enter now the new value for the CV, e.g. 15 (double-digit).
 Activate the reversion of the driving direction for confirmation.
The lighting flashes.

 You may now enter further values, which are going to be changed.
The programming mode is going to be left by selection of CV80 or by turning off and on the track power
(push STOP-button and then again GO-button).
Long-Mode
 You get the long-mode by entering in short-mode value 07 in CV07 at first.
The decoder confirms changing in long-mode by slow flashing of the lighting.
Enter now the hundreds- and tens digit of the CV, which you want to change.

Example: CV124 shall be changed: Enter '12'.
 Activate the reversion of the driving direction for confirmation. The lighting flashes long and short (peri-
odically).
 Enter now the unit-place of the CV in double-digit. See example: '04'.
Activate the reversion of the driving direction for confirmation. The lighting flashes long and short (peri-

odically). The decoder waits now for entering the CV-value.
28