Safety; Description; Function - Nederman 160E Series Bedienungsanleitung

3

Safety

WARNING!
• The 160E with 1 phase motor may only be connected to a grounded power
socket of the same voltage as stated on the machine data plate.
• A damaged component should immediately be replaced with a new genuine
spare part. Electrical components may only be replaced by a person with
the necessary expertise.
• The appliance must be disconnected from the power (remove the plug
from the power socket) before carrying out any form of intervention, e.g.
dismantling the motor assembly or replacing a micro-filter.
• Take care not to spread dust when changing the plastic sack and when
replacing the micro-filter. Wear an approved breathing mask in the case of
hazardous dust.
• For reasons of safety, do not put the vacuum hose inlet near the eyes, ears or
other part of the body.
• The 160E is not classified as a wet vacuum cleaner. Large amounts of water
may not be sucked into the unit. However, it may be used for damp material
and in a damp environment.
• Hot or red-hot material, flammable fluids, explosive or health-impairing
fumes as well as dust that could cause a dust explosion must not be sucked
into the 160E. Neither must the appliance be used in environments where
such material exists.
• Do not operate the 160E with a 1 phase motor when the vacuum is almost
or fully restricted. Little or no airflow results in overheating of the motor.
4

Description

4.1

Function

Electrical driven, 1-phase with separately cooled motors. The appliance can be
provided with manual and automatic start/stop modes depending on the model.
With automatic start/stop, the appliance is controlled by a connected electric
tool.
The rated power, voltage, safety class, flow, working pressure, max pressure,
etc. are stated on the machine data plate. The noise level during normal
operation is 75 dB(A) according to ISO 11201.
Dust separation takes place in three stages:
• Stage 1 is a collecting receptacle into which larger particles fall.
• Stage 2 is a fine filter.
• Stage 3 is a micro-filter (optional) with a degree of separation > 99.997%
(DOP).
Coarse particles are separated directly into the collecting receptacle's plastic
sack.
If the appliance is supplied with a closed filter bag instead of a plastic sack,
most of the dust will be deposited there. Fine dust follows the upward moving
flow of air and is deposited on the outside of the filters. The appliance has
a manual function for cleaning the fine filters. The principle of the cleaning
function is that the control is switched on, creating a pressure shock to dislodge
160E Series EN
11