Declaration Of Conformity; General Safety Rules - Hilti PR 30-HVS A12 Bedienungsanleitung

Product information
Rotating laser
Generation
Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety
2.1 Basic information concerning safety
Read all safety instructions and other instructions. Failure to observe the safety instructions and other
instructions may result in electric shock, fire and/or serious injury.
Retain all safety precautions and instructions for future reference. The term "electric tool" used in the
safety instructions refers to your mains-operated (corded) electric tool or battery-operated (cordless) electric
tool.

2.2 General safety rules

▶ Stay alert, watch what you are doing and use common sense when operating an electric tool. Do
not use an electric tool while you are tired or under the influence of drugs, alcohol or medication.
A moment of inattention while operating the electric tool may result in serious personal injury.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Keep laser devices out of reach of children.
▶ Laser radiation in excess of Class 2 may be emitted if the device is opened without following the correct
procedures. Have the device repaired only by Hilti Service.
▶ Laser beams should be projected well above or well below eye height.
▶ Take the influences of the surrounding area into account. Do not use the device where there is a
risk of fire or explosion.
▶ Statement in accordance with FCC §15.21: Changes or modifications not expressly approved by Hilti
may restrict the user's authorization to operate the equipment.
▶ You must check the accuracy of the device after it has been dropped or subjected to other
mechanical stresses.
▶ When the device is brought into a warm environment from very cold conditions, or vice-versa,
allow it to become acclimatized before use.
▶ Make sure that the device is mounted securely when adapters or accessories are used.
▶ Keep the laser exit aperture clean to avoid measurement errors.
▶ Although the tool is designed for the tough conditions of jobsite use, as with other optical and
electronic instruments (e.g. binoculars, spectacles, cameras) it should be treated with care.
▶ Although the tool is protected to prevent entry of dampness, it should be wiped dry each time
before being put away in its transport container.
▶ Check the tool before using it for important measuring work.
▶ Check the accuracy of the measurements several times during use of the tool.
▶ Ensure that the workplace is well lit.
▶ Do not expose the laser to rain or wet conditions.
▶ Avoid touching the contacts.
▶ Maintain the tool carefully. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the tool's operation. Have damaged parts repaired before
using the tool. Many accidents are caused by poorly maintained tools.
2.3 Proper preparation of the working area
▶ Secure the area in which you will be taking measurements. Make sure that the laser beam is not
directed toward other persons or toward yourself while setting up the laser tool.
▶ Avoid unfavorable body positions when working from ladders. Make sure you work from a safe
stance and stay in balance at all times.
Printed: 10.11.2016 | Doc-Nr: PUB / 5301171 / 000 / 01
PR 30-HVS A12
02
English 21