Clock Functions - Zanussi ZOP37902XU Benutzerinformation

Oven function
Defrost
Pyrolysis

CLOCK FUNCTIONS

CLOCK FUNCTIONS TABLE
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE
MINDER
00:00
COUNT UP
TIMER
8
Application
To defrost food (vegetables
and fruit). The defrosting
time depends on the
amount and size of the fro-
zen food.
To turn on the pyrolytic
cleaning of the oven. This
function burns off residual
dirt in the oven.
Application
To show or change the time
of day. You can change the
time of day only when the
oven is off.
To set how long the oven
works. Use only when a
heating function is set.
To set when the oven turns
off. Use only when a heat-
ing function is set.
Combination of DURATION
and END function.
Use to set a countdown
time. This function has no
effect on the operation of
the oven. You can set the
MINUTE MINDER at any
time, also if the oven is off.
If you do not set any other
clock function the COUNT
UP TIMER automatically
monitor how long the oven
works.
It is on immediately when
the oven starts to heat.
The Count Up Timer cannot
be used with the functions:
DURATION, END.
SETTING A HEATING FUNCTION
1. Turn the knob for the heating functions to
select a heating function.
2. Turn the control knob to select the
temperature.
The lamp turns on when the oven operates.
3. To turn off the oven, turn the knob for the
heating functions to the off position.
HEAT-UP INDICATOR
When the oven function operates, the bars in the
display appear one by one when the
temperature in the oven increases, and disappear
when it decreases.
SETTING AND CHANGING THE TIME
After the first connection to the mains, wait until the
display shows and "12:00". "12" flashes.
1. Press or to set the hours.
2. Press to confirm and set the minutes.
The display shows
flashes.
3. Press or to set the current minutes.
4. Press to confirm or the set time of day will
be saved automatically after 5 seconds.
The display shows the new time.
To change the time of day press
again until the indicator for the time of day
flashes in the display.
SETTING THE DURATION FUNCTION
1. Set a heating function.
2. Press again and again until
flash.
3. Press or to set the minutes and then the
hours. Press to confirm.
When the set Duration time ends the signal sounds
for 2 minutes. and time setting flash in the
display. The oven turns off automatically.
4. Press any button or open the oven door to stop
the signal.
5. Turn the knob for the heating functions to the
off position.
SETTING THE END FUNCTION
1. Set a heating function.
and the set hour. "00"
again and
starts to