Beissbarth Tesla VLH 2140 Originalbetriebsanleitung Seite 29

5.9.3 Support arms
Each lifting carriage has two support arms of equal
length.
Version
Length (front and back)
The support arms are of telescopic design and can
be swivelled in the lower lifting range. As of a lifting
height of approx. 20 cm, the support arms are locked
automatically to stop the mounts slipping off the
specified jacking points.
!
With maximum load, the load distribution between
the pairs of support arms should be no more
than 3 : 1.
5.9.4 Mounts and spacer sleeves
A mount is provided at the end of each support arm.
1
2
3
Fig. 5: Mount
1 Mount with rubber element
2 Height adjustment thread
3 Support arm
The mounts are positioned under the specified vehicle
jacking points and are turned to adjust the height. A
locking element stops the mounts being screwed out
too far.
i
Use spacer sleeves if the height adjustment of the
mounts is not sufficient.
i
Spacer sleeves are not included in the standard
scope of delivery.
!
Use only original Beissbarth spacer sleeves!
!
Use is only to be made of one spacer sleeve per
support arm. Spacer sleeves must never be stacked
on top of one another!
Beissbarth GmbH
Long support arms
726 — 1447 mm, 3-piece
Company obligations | VLH 2140 | 29
5.9.5 Fixture for Tesla Roadster
A special fixture is provided for the two rear support
arms of the Tesla Roadster. They can be purchased
under part number 1 692 871 558 from Beissbarth
customer service.
Fig. 6: Fixture for Tesla Roadster
!
When lifting vehicles with this fixture, always follow
the manufacturer's instructions!
en
|
1 692 826 073 2017-03-29